What Can We Expect From The Innokin Endura T22 Pro Kit?
We this kit is based on the Innokin Endura T22 kit but with some updates…
For a start the mod has a lot of extra features without being too complicated to put new vapers off.
Inside the mod is a 3000mAh battery which you charge using the on board USB Type C port.
You can charge at up to a 2A charge rate using a suitable adaptor which means this should charge a lot quicker than the older Micro USB kits.
There is a fire button which also has an LED indicator which informs of the battery capacity remaining by changing colour.
Instead of a screen there are 4 LED indicators below the fire button to display the selected power level – I will talk more about these in the Basic Operation section.
Included in the kit is the new T18E Pro tank which uses the T18 range of coils – I will again go into detail which coils are compatible further in the review.
There are 6 colours to choose from: Matte Black, Steel Grey, Ruby Red, Royal Blue, Rose Gold and Brushed Silver.
Thank you to Innokin for sending me these for review – I will report back honestly on my findings of the devices I have received.
Inside the Innokin Endura T22 Pro Kit Box
- Innokin Endura T22 Pro mod
- Prism T18E Pro tank
- Spare drip tip
- 1.7ohm coil (installed)
- 1.5ohm coil
- USB Type C Cable
- User manual
Innokin Endura T22 Pro Mod Specs
- Size: 79×34.8×25.8mm
- Battery: 3000mah (internal)
- Display: LED indicators
- Output: 9.5W, 11W, 12.5W and 13.5W
- Type C USB charging – 2A charge rate
- Resistance range: 0.6-3.5ohm
- Avatar Smart Chip
- On / Off switch located on mod base
Innokin Endura T18E Pro Tank Specs
- Size: 20x42mm (not including drip tip)
- Capacity: 2ml
- Coil: T18E / M18 Coils
- Top slide fill
Do let me know your thoughts and opinions in the comments below!